Friday - 6 July 2012

     Mr. Mazran and Engr. Siva briefing about rule and time attendance to follow during this industrial training:


Time:    9am   - 10am (Report blog)

            10am - 12.30pm (Daily chores)

            1pm   - 2pm (Break)

            5pm (Dismissed) 


Schedule:

General Task:

1. PCB / Soldering

2. PLC

3. IP Camera

4. Mechanical Prototype

5. Visual Basic (VB) : Week 5

Specific Task: Website Team

Today I have learned 1st task PCB / Soldering which divide into two soldering technique, surface mount device (SMD) and through hole technology. The book below is our reference, as module 4, 6 and 7 is about soldering, surface mount assemblies and through-hole technology. Before start solder, make sure that window is open to work in well-ventilated area. The other soldering guide can be refer to this link: http://www.kpsec.freeuk.com/solder.htm

All LI practical student were given 28 pin PIC micro controller board to complete both of soldering technique.

Surface Mount Assemblies

...

Procedure:

...

This is my PCB board after complete soldering surface mount device:

SMD: Front and back view